EXERCISE GUIDE · UPPER CHEST · DUMBBELLS
How to do an incline dumbbell press
The incline dumbbell press is a chest press done on a bench set at an incline. You lower a dumbbell in each hand to the sides of your upper chest, then press both up until your arms are straight. Compared with a flat press, the incline moves more of the work to the upper part of your chest and the front of your shoulders.
Each arm moves on its own, so a weaker side cannot lean on the stronger one. Getting the dumbbells into place and putting them down safely is part of the lift, so the steps cover both.

- Main muscles
- Upper chest
- Also works
- Chest, front shoulders, triceps
- Equipment
- Two dumbbells and an adjustable bench
- Level
- Beginner to intermediate
- In free Clip2Fit workouts
- Push Day Power
How to do it
- Set an adjustable bench to a low incline, about 30 to 45 degrees. Sit with your back against it and stand the dumbbells on end on your thighs, close to your knees.
- Lie back and, as you do, lift one knee and then the other to help push each dumbbell up to your shoulder. Then plant both feet flat on the floor, a bit wider than your hips.
- Press the dumbbells up over your shoulders with your palms facing forward. Pull your shoulder blades back and down into the bench and keep your chest up.
- Bend your elbows and lower the dumbbells slowly to the sides of your upper chest. Keep your forearms about vertical and your elbows angled slightly in toward your body.
- Stop when the dumbbells are about level with your chest and you feel a stretch across it. Keep your shoulder blades in place and your hips on the seat.
- Press the dumbbells back up until your arms are straight. Let them move slightly closer together at the top without touching.
- To finish, bring the dumbbells to your chest, then raise your knees and sit up with the dumbbells on your thighs.
Muscles worked
Your chest does most of the pressing. With the bench inclined, the upper fibers near your collarbones take a bigger share of the work than on a flat bench, and the rest of the chest still helps. The front of your shoulders works hard too, more so as the bench gets steeper. Your triceps straighten your elbows at the top, and your upper back keeps your shoulder blades steady against the bench.
Common mistakes
- Bench set too steep
- A very steep bench turns the lift into more of a shoulder press. Lower it a notch or two until you feel the work mostly in your upper chest.
- Elbows flared straight out
- Angle your elbows slightly in toward your body. Many people find this easier on the shoulder joint.
- Shoulders rolling forward at the top
- Keep your shoulder blades pressed back into the bench for the whole set. Stop when your arms are straight, and do not reach the dumbbells toward the ceiling.
- Short, bouncy reps
- Lower the dumbbells under control until they are about level with your chest, pause for a moment, then press.
- Hips lifting off the seat
- Keep your glutes on the bench and your feet flat. If you have to push your hips up to finish a rep, use lighter dumbbells.
Make it easier or harder
- Easier: Use lighter dumbbells and a lower incline. An incline push-up with your hands on a sturdy bench, or a seated chest press machine, also takes away the balance work.
- Harder: Take three seconds to lower the dumbbells on every rep. You can also press one arm at a time while the other arm holds its dumbbell still above your shoulder.
How Clip2Fit programs it
| Workout | Version | Sets × target | Rest | Cue |
|---|---|---|---|---|
| Push Day Power | Dumbbell Incline Bench Press | 3 × 8–10 reps | 120 s | Shoulder blades back, lower to upper chest. |
Incline vs flat dumbbell press
Both lifts train the chest, the front of the shoulders and the triceps. The flat press spreads the work over the whole chest, and most people can lift a bit more on it. The incline press moves more of the load to the upper chest and the front of the shoulders. Many programs use one as the main press and the other as a second chest exercise.
Alternatives
- Barbell: Incline barbell bench press. Use a spotter, or set the safety arms just below chest height.
- Machines and cables: Incline chest press machine, or a low-to-high cable fly for the upper chest.
- No equipment: Push-up with your feet raised on a bench or step, which shifts more of the work toward the upper chest and shoulders.
Who should ask first
If you have shoulder pain or a past shoulder injury, ask a health professional before you start pressing. Pick dumbbells you can get into position and put down with control, and ask for a spotter when you work close to your limit. Stop any set that causes pain.
All exercise guides · Free workouts
Updated 2026-10-31. Steps written with AI help from our licensed exercise data, checked against the demo and reviewed by the Clip2Fit team. General fitness information, not medical advice.